PLA readers

New Last product update:
13/02/2020

Netronix PLA-D6L

  • PLA-D6L
  • PLA-D6L
  • PLA-D6L
  • PLA-D6L

The product may vary in appearance. Before purchasing, please read the description of the product, its technical documentation or contact us.

  • Facebook
  • Google Plus
  • LinkedIn

PLA-D6L is a RFID proximity card reader from the Unique (EM4102), HITAG1/S, HITAG2, HID ISOProx®II families operating at 125kHz. The reader is equipped with 1-Wire® (Dallas DS1990 emulation), WIEGAND and serial UART-TTL, RS232-5V interfaces. The reader is equipped with a 1m long cable terminated with a male 2x3-pin Molex MicroFit3.0 plug. The reader has a built-in antenna, buzzer and two LED indicators. It has been designed in accordance with the requirements of the E-mark automotive safety standard.

Product have following functionalities

PLA-D6L is the direct successor of the PLA-UDK and PLA-2DK readers, which goes into EOL status and are not recommended for use in new applications.

  • supports RFID transponders from the Unique (EM4102), HITAG1/S, HITAG2, HID ISOProx®II families operating at 125kHz,
  • 1-Wire (DS1990 emulation) and WIEGAND interfaces,
  • UART-TTL, RS232-5V serial interfaces,
  • low energy consumption,
  • wide range of input supply voltage,
  • built-in antenna, buzzer and two LED indicators for status,
  • software update via interface,
  • configuration using a button or a protocol,
  • compact, flat housing,
  • designed in accordance with the requirements of E-mark.

Specification

Supported standardsUnique (EM4102), HITAG1/S, HITAG2, HID ISOProx®II
Operating frequency125kHz
Read rangeup to 8cm depends on transponder
Interface1-Wire, WIEGAND, UART-TTL, RS232-5V
RelayNo
AntennaYes
LEDYes
BuzzerYes
Connector2x3-pin male type Molex MicroFit3.0
Cable length1m
Supply voltage7 - 32V
Max. current consumptionUp to 5mA (for 1-Wire, WIEGAND), 12mA (for serial interfaces)
Working temperature-20°C to +65°C
Size (mm)54 x 85 x 7