UW-R4G is wall mount RFID proximity card and transponders reader from the MIFARE® Classic, Plus, Ultralight C, DESFire, iCLASS (tylko CSN), ICODE® SLI operating at 13,56MHz high frequency, equipped with an RS485 interface with Netronix and MODBUS-RTU transmission protocol. Reader has also built-in antenna, buzzer, relay and two LED indicatiors and RTC clock.
- Cards memory with a built-in bolt controller,
- RS485 interface,
- Netronix and MODBUS-RTU transmission protocol
- Addressability on the RS485 bus,
- Built-in relay, buzzer,
- Built-in button on the front panel and signal LEDs,
- Built-in return button to factory settings,
- Built-in tamper with spring,
- Anticollision pin synchronizing readers working close to each other,
- Configuring two-state inputs / outputs,
- Configuration of buzzer, relay and LED behavior,
- Control of two-state outputs,
- Reading binary inputs,
- Data protected by a password,
- RTC clock,
- Event memory with the possibility of masking the trigger sources,
- Software upgrade via RS-485 interface using the NEFIR utility,
|Supported standards||ICODE® SLI
MIFARE® Ultralight C
iCLASS (tylko CSN)
|Interface||RS-485, protokół MODBUS RTU|
|Read range||up to 8cm*|
|Supply voltage||8 - 16V|
|Max. current consumption||200mA|
|Size (mm)||82 x 82 x 22|
Gamma Sp. z o.o.Kacza 6A
- 22 862 75 00
Transfer Multisort Elektronik Sp. z o.o.Ustronna 41
- 42 645 55 55
SOS electronic s.r.o.Pri prachárni 16
040 11 Košice
Ask for support
We are at your service for any questions related to our products.
Cooperation with Netronix is always the right decision!
Without stopping, we change with the changing market.
We offer our clients not only ready-made products, but also individual solutions.